- 积分
- 399
- 回帖
- 0
- 西莫币
-
- 贡献
-
- 威望
-
- 存款
-
- 阅读权限
- 20
- 最后登录
- 1970-1-1
该用户从未签到
|
楼主 |
发表于 2010-11-25 12:51
|
显示全部楼层
来自: 中国北京
Brushless Permanent Magnet Synchronous motor otherwise known as PMAC motor. Input voltage of 30-72 VDC. 100 amps continuous, up to 300 amps for 30 seconds. The phase resistance is very low at 10 milli-ohms, so it is 90% efficient. This motor has a built-in cooling fan set for a CCW direction, but can be run CW with optional fan. Motor weight is 22 pounds.
This motor is a direct replacement for the Etek (Briggs & Stratton) brushed DC motor. It is an Axial Air Gap permanent magnet motor. This technology is very compact. Highest potential power to weight ratio of any PM motor technology.
Commutation is accomplished with an internal Hall Cell assembly, connected to the 6-pin external wire harness.
This Brushless motor requires a 3 Phase 8 Pole PMAC controller. |
|