JMAG-RT做直线电机效率Map图报错

wx_B2fpIAil

Maxwell暂不支持直线电机的效率Map，Jmag designer也不支持，我用JMAG-RT做直线电机效率Map图时，出现以下错误，但没有找到实质的解决方法，各位有没有遇到类似情况的？
1. The solver module was aborted.
The solver module RTMaker was aborted.
Please confirm the model and settings.
Please check below when MPP solver is used.
- using 64bit module.
- registered your information in mpirun, mpiexec, or mpiexec.hydra.

Command line:
D:/Program Files/JMAG-Designer20.0\RTMaker.exe -in=C:/Users/bibin/JMAG/JMAG_RT/RT_DATA-230411000951\run\Mesh Data for RT Eff Map.jcf -xml=C:/Users/bibin/JMAG/JMAG_RT/RT_DATA-230411000951\run\rtmotor.xml -rtt=bin

Solver : RTMaker
Version : 2020.11r
Code : 120056

2. Failed RT

Failed RT.
Solver : ExecSolver
Version : 2020.11r
Code : 120074

3. The specific extension files could not be copied.
file copy from .\run\*.rtt to .\*.rtt not succeed.

.\run\*.rtt may not have been created.
Check if there are any problems in the analysis results.


Solver : ExecSolver
Version : 2020.11r
Code : 120147

4. Unable to run the JMAG-RT
* The conditions may not be set properly for the magnetic field analysis. Check the condtions.
* If [Distributed Calculation] is selected, check the settings for the remote system (server and client).
* If the number of solvers that can be used simultanously is set to more than than two, the number of licenses may be insufficient. Set the number of owned licenses to the number of solvers to be used simultanously.
* They file may not have been generated correctly. Turn on [Recalculate Only Failed Cases].

Solver : RTMaker
Version : 2012.08.200
Code : 18070

562

磁场分析的条件可能设置不正确。检查条件。

*如果选择了[分布式计算]，请检查远程系统（服务器和客户端）的设置。

*如果可同时使用的解算器数量设置为两个以上，则许可证数量可能不足。将拥有的许可证数量设置为要同时使用的解算器数量。

*他们的文件可能没有正确生成。启用[仅重新计算失败案例]。

wx_B2fpIAil

562 发表于 2023-4-17 15:23
磁场分析的条件可能设置不正确。检查条件。

*如果选择了[分布式计算]，请检查远程系统（服务器和客户端 ...

把和涡流损耗相关的设置都要去掉就可以了。另外，JMAG-RT似乎也是不支持直线电机的效率MAP。