Maxwell to LMS Virtual.Lab Coupling

yayay2010

Maxwell supports one-way coupling with Siemens® LMS Virtual.Lab™.

To enable output of Maxwell solutions for use in Virtual.Lab:

1. Either select Maxwell 2D (or Maxwell3D)>Enable Harmonic Force Calculation, or right-click on the Design in the project tree and select Enable Harmonic Force Calculation to open the Enable Harmonic Force Dialog box.

2. On the General tab, to enable output of Maxwell solutions for Virtual.Lab, check only one object. The informational text informs you that harmonic force calculation is disabled, and confirms that only one object has been selected.



3. On the Link to LMS tab, enter the path to the Output directory you want to use for the Vir-tual.Lab files generated by Maxwell.



4. Export settings to allow you to control collection of data for export to Virtual.Lab. You can choose to include No steps or All steps. The Steps from end setting allows you to choose the number of steps from the end for which data is collected. Alternatively, you can select a Range of steps, for which you can set a data collection Start step and a data collection End step.

5. Click OK to close the dialog box.

6. Solve the Maxwell project.

The two Virtual.Lab .unv files generated by Maxwell will be in the output directory you spec-ified

zhangming

顶起！！！！做声音仿真的这么少啊？

hongjianfeng

请问其中的Step是什么意思？

YSHL

楼主用的什么版本的maxwell，2014版没有楼主所说的界面。

ZHANG12345678

您好打扰了，不知道您现在还有做电机的噪声仿真，我先问一下maxwell可不可以导出多转速的电磁力到lms中呢？我用参数化试了一下但是结果不是多转速的情况。

laijianbin1992

ZHANG12345678 发表于 2020-5-22 11:41
您好打扰了，不知道您现在还有做电机的噪声仿真，我先问一下maxwell可不可以导出多转速的电磁力到lms中呢？ ...

兄弟，我也在研究这个，貌似maxwell电磁力导出到VL只能一个一个导出

laijianbin1992

laijianbin1992 发表于 2020-5-23 12:30
兄弟，我也在研究这个，貌似maxwell电磁力导出到VL只能一个一个导出

电磁力一个一个导出后，试了好久在VL里面还整合不起来

ZHANG12345678

laijianbin1992 发表于 2020-5-23 12:33
电磁力一个一个导出后，试了好久在VL里面还整合不起来

想计算多转速的工况，但是现在搞不了，用workbench实在是太费时间了，而且完整的模型基本上跑不出来

GDY257954

laijianbin1992 发表于 2020-5-23 12:30
兄弟，我也在研究这个，貌似maxwell电磁力导出到VL只能一个一个导出

Maxwell只能与ANSYS WB实施多转速自动连接，连接到LMS只能一个一个