关于ansoftlinks导出模型到HFSS

yingjuan

近日在尝试利用ansoftlinks3.0导出模型到HFSS.但是在HFSS中仿真的时候出现问题,请问有哪位朋友遇到过这样的问题吗?麻烦帮忙解决一下,谢谢.:handshake

以下为一部分报错说明:
Model Summary
Model: d:/ansoft/hfss_temp_1.pjt/Setup1
Date : 01/18/2008 17:26:09

The Summary of Results
3813 errors detected.
  Model errors=    15
  Contact errors=  3748
  Proximity errors= 50
A section under the topic titled Meshmaker in the on line help
   has the glossary of terms used in this report. It also describes
   the analysis and has suggestions about workarounds.

Model Analysis Results
Edge length ratio                                Ref Number:64
Two edges on a loop have very different lengths

  ratio= 3.423671e-007
  Face: id = 12734, on  Body: "TD___Pad_330" id= 12724
    Face bounding box:
      setcurpos [ 3.335325e+001, 5.405958e+001, 4.900000e-001 ]
      setcurpos [ 5.115941e+001, 8.539747e+001, 4.900000e-001 ]
    The longest edge:
      type = straight
      end1 = setcurpos [4.981222e+001, 6.256099e+001, 4.900000e-001]
      end2 = setcurpos [3.812899e+001, 7.424448e+001, 4.900000e-001]
    The small edge:
      type = straight
      end1 = setcurpos [3.812899e+001, 7.424448e+001, 4.900000e-001]
      end2 = setcurpos [3.812898e+001, 7.424448e+001, 4.900000e-001]

hust2008

不错   谢谢了  我喜欢  呵呵

xiaoai36

我最近也在做这方面的东西，等我搞通这部分，看能不能帮你解决！

fairy_1002

帮你顶一下，这个问题我也很期待。

purian

希望有人来解释一下哈,顺便学习一下!

yonghuming88

我的HFSS project菜单是灰色的 不能用 什么原因？