求指导 一个涡流驱动器的问题

wxwsjjm1

求助大家：为什么我mesh时候
出现
The problem occurred in contact face
It failed in the recognition of contact face.
Therefore, the Mesh is not created.
FACE ID:17
FACE ID:582

Solution1.Please confirm whether a position of solid face correspond accurately. When not corresponding, please correct the position of the model. Tolerance for contact is 1.000000e-009[m].
Solution2.Please add the division line in this model so that the edge line of the face appear on other face.
Solution3.When there are small solid faces, Please correct the model shape to be lost of the small solid faces.


看似是 永磁体和后面磁钢有交叉 我该怎么做呢
本人初学 求指导