- 积分
- 202
- 回帖
- 0
- 西莫币
-
- 贡献
-
- 威望
-
- 存款
-
- 阅读权限
- 10
- 最后登录
- 1970-1-1
该用户从未签到
|
![](static/image/common/ico_lz.png)
楼主 |
发表于 2012-11-10 11:51
|
显示全部楼层
mustech2012 发表于 2012-11-9 18:17
thx legned but i have n't a credit card we have nt this service in my country,
i have a question fo ...
No, I'm learning Speed now. Compared to SPEED, I'm more familiar with Ansoft.
I just confuesd about the slot definition of the SPEED software, it can't provide the knife slot I need.
I calculated a regular slot induction motor recently, and I found there are difference between RMxprt and SPEED design result. However, the RMxprt result is more consistent with our traditional design result. So, I was wondering if I continue using SPEED. |
|