3D电磁感应，U型初级线圈，次级为何线圈无电压？
所见模型，网格，云图，磁感应线如图所示~但是结果无电压。 EL= 26370INDEPENDENT VOLTAGE SOURCE CIRCU124KOPT(1)= 4
NODES = 4534 4535 4536
VOLTAGE SOURCE =50.000 (Volt) (real)
VOLTAGE =50.000 (Volt) (real)
CURRENT =-0.24797E-01 (Ampere)(real)
POWER (ABSORP) =-0.61992 (Watt) (real) (output if negative)
EL= 26371STRANDED COIL CURRENT SOURCE CIRCU124KOPT(1)= 5
NODES = 4534 4535 775
SCAL =1.0000
VOLTAGE =50.000 (Volt) (real)
CURRENT = 0.24797E-01 (Ampere)(real)
POWER (LOSSES) = 0.61992 (Watt) (real)
EL= 26372INDEPENDENT VOLTAGE SOURCE CIRCU124KOPT(1)= 4
NODES = 4539 4540 4541
VOLTAGE SOURCE =50.000 (Volt) (real)
VOLTAGE =50.000 (Volt) (real)
CURRENT =-0.25754E-01 (Ampere)(real)
POWER (ABSORP) =-0.64385 (Watt) (real) (output if negative)
EL= 26373STRANDED COIL CURRENT SOURCE CIRCU124KOPT(1)= 5
NODES = 4539 4540 858
SCAL =1.0000
VOLTAGE =50.000 (Volt) (real)
CURRENT = 0.25754E-01 (Ampere)(real)
POWER (LOSSES) = 0.64385 (Watt) (real)
EL= 26374RESISTOR CIRCU124KOPT(1)= 0
NODES = 4544 4545
RES =1000.0 (Ohm)
VOLTAGE =0.0000 (Volt) (real)
CURRENT =0.0000 (Ampere)(real)
POWER (ABSORP) =0.0000 (Watt) (real) (output if negative)
EL= 26375STRANDED COIL CURRENT SOURCE CIRCU124KOPT(1)= 5
NODES = 4544 4545 1066
SCAL =1.0000
VOLTAGE =0.0000 (Volt) (real)
CURRENT =0.0000 (Ampere)(real)
POWER (ABSORP) =0.0000 (Watt) (real) (output if negative) 初级电压电流正常，次级无电压。。不知道原因，急求高手帮忙解决下~~~~不胜感谢。。。 这个是模型命令流，最后没加边界平行条件和谐波分析方法和频率。请高手帮忙看看哪里出错了？ 怎么没人帮帮我额~~~~~
页:
[1]