motorCAD与optislang联调
本帖最后由 字符串 于 2026-1-20 21:45 编辑我python代码定义的是矩形导体，为什么进行参数灵敏度分析时生成的模型是圆形截面导体，下面是代码
mcApp.SetVariable('WindingLayers', 2) # 1=single layer, 2=double layer
mcApp.SetVariable('MagTurnsConductor', p_Turns_Coil) # Turns per coil/conductor
mcApp.SetVariable('ParallelPaths', p_Parallel_Path) # Parallel paths per phase
#mcApp.SetVariable('RequestedGrossSlotFillFactor', p_Slot_Fill) # Slot fill factor (gross)
#mcApp.SetVariable('Wire_Type_Stator', 3)
mcApp.SetVariable('Wire_Type', 3)
mcApp.SetVariable('Wire_Type', 'Rectangular')
页:
[1]