xjhuoran 发表于 2016-11-3 16:11

JMAG仿真单边直线电机对称条件怎么设置?

老是提示Cannot find the pair of node on Periodic boundary
Cannot find the pair of node on Periodic boundary.
1. Did you set periodic boundary inside model?
Please modify periodic boudary.
2. Please check periodic angle.
Anti clock-wise is positive angle.
3. Duplicate nodes.
Please check the duplicate nodes except for the sliding mesh.
4. Periodic boundary is set on Tetra element.
This warning may be ignored.
5. This model generate by Meshgenerator.
This warning may be ignored.
Number of nodes set on master Periodic Boundary is 15.
Number of nodes found on slave Periodic Boundary is 1.
Now,threshold value is .
需要加什么类型的边界条件?气隙需要自己画吗?

xjhuoran 发表于 2016-11-3 20:07

边界条件怎么设置?求有经验的前辈指点
页: [1]
查看完整版本: JMAG仿真单边直线电机对称条件怎么设置?