zhangwei214lxd 发表于 2015-9-17 16:36

MATLAB问题求助

下面是我搭仿真出的错误报告,求大神帮忙怎么修改
The sample time of 'PCC_observer/observer/Add2' at input port 2 is different from the sample time of 'PCC_observer/observer/Discrete Transfer Fcn' at output port 1. Consider inserting a Rate Transition block between the two ports. Alternatively, you can control the diagnostic action for unspecified rate transitions on the Sample Time Diagnostics pane of the Configuration Parameters dialog box.

百慕大 发表于 2015-9-21 16:10

你的各个模块之间传输速率不一致,考虑用 Rate Transition block 模块来解决这个问题试试
页: [1]
查看完整版本: MATLAB问题求助