异步电机 IP56防强喷水的水量
现在遇到一个case关于电机防护等级的问题,IP56电机是防海浪和强喷水,请问有没有具体的水量的说明?强喷水强到什么程度?求高手指教 本帖最后由 1-1-1 于 2012-5-24 12:44 编辑The test is made by spraying the machine from all practicable directions with a stream of water
from a standard test nozzle as shown in figure 6. The conditions to be observed are as follows:
– nozzle internal diameter: 12,5 mm;
– delivery rate: 95 – 105 I/min
– water pressure at the nozzle: approximately 100 kPa (1 bar) (see NOTE 1);
– test duration per m2 of surface area of the machine: 1 min;
– minimum test duration: 3 min;
– distance from nozzle to machine surface: approximately 3 m (see NOTE 2).
NOTE 1 The measurement of the water pressure may be replaced by that of the height to which the spray of the nozzle freely rises:
Pressure: 30 kPa (0,3 bar) Height: 2,5 m
Pressure: 100 kPa (1 bar) Height: 8 m
NOTE 2 The distance of the nozzle to the machine under test, for degrees 5 and 6, was set at 3 m for practical
reasons; it may be reduced in order to test the machine from every direction. 我查了下资料，上面有张图片，好像用满脸盆水泼上去的那种感觉。 水量压力以及时间要求,我不是都给了吗? IEC有标准的啊
页:
[1]